871 Imprint Adjustment
Remove the screw on the top of the cover as shown. Then lilt the back of the
cover and tilt it forward. You may have to lift up on the handle to free the
cover at the front. After the cover is loose, just slide it forward and let
it rest on the handle. Adjust screws in 1/8 turn increments or less and take
sample imprints between adjustments. To replace the cover, lift the handle
and slide the cover back, allowing it to hook. The cover can tilt back and
the screw can be replaced now. Note: When removing cover, the print mask may
come unhooked from the imprinter. See sheet 2 for instructions on replacing
the mask.
871 Mask Re-installation Instructions
To replace the print mask, hook the two tabs on the end of the mask
into the slots on the imprinter, as shown. Now rotate the mask up to the
notched shaft. (See diagram) Slip tab on the end of the mask over the notched
shaft. The mask can flex to allow it to go over the shaft. See diagrams.
Note: Mask needs to be in place to take an imprint.
